 |
|
| Call Us Toll Free: 1-877-438-5872 | |
Description:
The K.1 Sport is a multi-use, full featured helmet with aero styling and Bell's innovative Dominator chin bar design. The K.1's aero features enhance the helmet's aerodynamic stability in high-speed racing environments. The Snell SA2010 rated K.1 Sport is a great helmet for open wheel racers and kart racers who plan on moving into other forms of racing that require fire retardant interiors.
The K.1 Sport features a lightweight composite shell, comfortable interior fit and maximum ventilation with full chin bar, forehead and top vents. The K.1 Sport takes a 276 SRV Shield and each helmet comes with a clear shield and Bell visor strip as standard equipment.
The K.1 Sport also features Bell's redesigned face piece with recessed areas that allow for seamless radio integration and easy installation. Racers can also customize the fit of the K.1 Sport by using Bell's Cheek Pad Inserts in 5mm, 10mm, 15mm and 20mm sizes to tighten the fit in the cheek area. The helmet is available in White and Rubberized Matte Black finish - the rubberized surface is more resistant to finger prints and smudges than traditional flat finishes. The K.1 is pre-drilled for use with head and neck restraint devices.
• Ultra-Lightweight Composite Shell Technology
• Standard Eyeport
• Superior Chin Bar, Forehead & Top Ventilation • 276/3MM SRV Shield (SRV-2 Pivot System)
• E-Max Plus Multi Density Liner
• Available in White and Rubberized Matte Black
The K.1 Sport features a lightweight composite shell, comfortable interior fit and maximum ventilation with full chin bar, forehead and top vents. The K.1 Sport takes a 276 SRV Shield and each helmet comes with a clear shield and Bell visor strip as standard equipment.
The K.1 Sport also features Bell's redesigned face piece with recessed areas that allow for seamless radio integration and easy installation. Racers can also customize the fit of the K.1 Sport by using Bell's Cheek Pad Inserts in 5mm, 10mm, 15mm and 20mm sizes to tighten the fit in the cheek area. The helmet is available in White and Rubberized Matte Black finish - the rubberized surface is more resistant to finger prints and smudges than traditional flat finishes. The K.1 is pre-drilled for use with head and neck restraint devices.
• Ultra-Lightweight Composite Shell Technology
• Standard Eyeport
• Superior Chin Bar, Forehead & Top Ventilation • 276/3MM SRV Shield (SRV-2 Pivot System)
• E-Max Plus Multi Density Liner
• Available in White and Rubberized Matte Black
|
Primary Use:
Auto Racing Rating: SA2010 / FIA8858 Eye Port: Standard Interior Liner: Interior Shell foam: E-Max Plus Colors Available: White, Rubberized Black Origin: Sizes Available: 6-7/8 thu 7-3/4 Shell Material: Fiber-Tech Composite Adjustable Air Vents: Yes Fresh Air Inlet Port: No Drilled for Hans: Yes |
Sizing Charts:
To calculate helmet size, use a cloth tape measure or string to measure the circumference of your head.
Place the tape approximately 1” above the eyebrows, run it just above the ears and around the back of the
head at the point farthest from the forehead. Find your measurement on the table below to figure out your
helmet size. If you fall in-between sizes opt for the larger size.
RESOURCES:
RESOURCES:
- Helmet Sizing Chart (PDF, 171KB)
- Snell Helmet testing information (DOC, 84KB)
Recommended products:
Customers who bought this product also bought the following products:
|
|||||
